Handling The Product - Olympus CWPC-02 Bedienungsanleitung

Handling the Product

Do not use or store the unit in places such as listed below:
Doing so may cause malfunctions, defects, damage, fire, internal
clouding, or water leakage.
Areas exposed to direct sunlight and high temperatures (e.g. in a car, on
the beach, etc.)
Areas exposed to fire or overheating.
Water depths in excess of 3 meters.
Areas exposed to strong vibrations
Areas exposed to excessive temperatures or humidity.
Areas exposed to extreme temperature changes.
Areas exposed to organic solvents and corrosive gas.
This product is made of polycarbonate resin with high impact resistance,
but it could be damaged by scraping against rocks or other hard objects.
Striking or dropping it against a hard object may also break it.
This product its not designed to absorb impacts and protect the camera
inside. When this product is subjected to strong impacts or when heavy
objects are placed on it, the digital camera inside may be damaged.
Please handle with care.
When this product is not used for a long time, the waterproof packing and other
parts may deteriorate, leading to a decline in water resistant performance. Before
use, always perform the preliminary test and the final check.
When a flash is used with this product, the flash light will be obstructed
and shadows may appear in the corners of the picture. These shadows
may be particularly noticeable in close-up shooting with the camera set
to wide-angle. Check the picture before using the flash with the camera
is loaded in the Case.
Do not use the following chemicals for cleaning, corrosion prevention,
prevention of fogging, repair or other purposes. Applying any of these to
the product directly or indirectly (with the chemicals in vaporized state)
may cause cracking under high pressure or other problems.
Chemicals which cannot be used Explanation
Volatile organic solvents,
chemical detergents
Anticorrosion agent
Adhesive
Do not clean the product with alcohol, gasoline,
thinner or other volatile organic solvents or with
chemical detergents etc. Pure lukewarm water is
sufficient.
Do not use anticorrosion agents. The metal parts
use stainless steel or brass, and washing with
pure water is sufficient.
Do not use adhesive for repairs or other purposes.
When repair is required, please contact your
dealer or nearest Olympus Service Station.
E-6