Installation - Agilent Technologies TwisTorr 304 FS series Bedienungshandbuch

16 Instructions for Use

Installation

Installation

Do not install or use the controller in an environment exposed to
atmospheric agents (rain, snow, ice), dust, aggressive gases, or in
explosive environments or those with a high fire risk. During
operation, the following environmental conditions must be complied
with:


WARNING! For user safety, the Turbo controller must be powered by a 3-wire power cord
(see orderable parts table) and plug (internationally approved). Always use
this power cord and insert the plug in a socket with a suitable ground
connection to avoid electrical shock and to comply with EC requirements .
The high voltage developed inside the controller can cause severe injury or
death. Before installing or servicing the unit, always disconnect it from the
socket.
WARNING! To avoid injury to personnel and damage to the equipment, if the pump is
lying on a table, make sure it is steady. Never operate the Turbo pump if the
pump inlet is not connected to the system or blanked off.
136/178
temperature: from + 5 °C to +45 °C
relative humidity: 0 – 90 % (non-condensing)
TwisTorr 304 FS on board Controller User Manual / 87-901-028-01 (C)