General Information - Agilent Technologies TwisTorr 304 FS series Bedienungshandbuch

16 Instructions for Use

General Information

General Information

This equipment is destined for professional use. Before operating the
equipment, the user should read this instruction manual and any
other additional information supplied by Agilent. Agilent declines
any responsibility for non-compliance, even partial, with these
instructions, improper use by untrained persons, unauthorized
repairs of the equipment or use not complying with specific national
standards. The TwisTorr 304 FS on board controller is suitable for
use with TwisTorr 304 pumps. It is equipped with auxiliary
connectors that make it possible to power an additional fan, to
control the vent valve and for remote operation of the TwisTorr 304
FS on board by a host computer connected on a serial line (RS232 or
RS485). The following paragraphs contain all the information
necessary to guarantee operator safety when using the equipment.
For detailed information, refer to the "Technical Information"
appendix.
The following conventions are adopted in this manual:
Caution messages are displayed before procedures which, if not followed, may
CAUTION!
cause damage to the equipment.
WARNING! Warning messages are intended to draw the operator's attention to a
particular procedure or practice which, if not followed correctly, may cause
serious injury.
The notes contain important information taken from the text.
NOTE
134/178 TwisTorr 304 FS on board Controller User Manual / 87-901-028-01 (C)