Epson SureColor series Handbuch Seite 6

Applying with a roller
To prevent T-shirt fibers on the roller from sticking to
other T-shirts, use a different roller for each color on
the T-shirt.
A
Wet the roller by dipping it in a tray of pre-
treatment liquid.
B
Spread out the T-shirt on a flat surface.
C
Squeeze the pre-treatment liquid out of the roller
by pressing it against the edge of the tray, and
apply the liquid evenly.
We recommend applying to an area larger than
the target print area.
D
Fix the pre-treatment liquid with the heat press.
"Fixing the Pre-treatment Liquid (Heat
U
Press)" on page 7
Note:
You need to press the fibers flat to produce even
whiteness. Use a heat press to fix the pre-treatment
liquid since the fibers are not pressed flat in the
oven.
– Polyester Pre-treatment Liquid (T43R2) –
Applying with a sprayer
For details on using the sprayer, see the manual
supplied with the sprayer.
A
B
6
c
Important:
Depending on the type of sprayer, it may create a mist
when applying the pre-treatment liquid. Wear a mask,
protective eye-wear, and gloves as required, and make
sure the area is well ventilated while working with the
pre-treatment liquid.
Load the pre-treatment liquid into the sprayer.
Load the T-shirt into the sprayer, and then spray
the pre-treatment liquid evenly over the printing
surface.
We recommend applying to an area larger than
the target print area.
Note:
O Polyester pre-treatment liquid has a higher
viscosity than cotton pre-treatment liquid and
may produce a narrower spray, in which case
you may need to adjust sprayer to cover a
wider area.
O You can apply the liquid evenly if you run the
roller over the area after spraying.