Epson SureColor series Handbuch Seite 4

Opening the pre-treatment
liquid
A
Cut the cardboard along the perforations, and
then remove the tap from inside.
B
Pull the cap section out of the hole in the
cardboard.
c
Important:
Make sure you pull the cap section out of the hole
in the cardboard. If the cap is opened without
being pulled out, the pre-treatment liquid may
spill out.
– Polyester Pre-treatment Liquid (T43R2) –
C
D
E
4
Remove the cap.
Remove the tap from the bag and check that the
hole is visible.
If you cannot see the hole, turn the tap's handle
section until the hole is visible.
Note:
If you cannot see the hole or if the tap is damaged,
contact the store where you purchased the product.
Attach the tap.
c
Important:
Do not put waste liquid in the waste ink bottle as
it will solidify if mixed with waste ink.