Epson SureColor series Handbuch Seite 3

Agitating pre-treatment liquid
Agitate the pre-treatment liquid as described below
before opening the package. Failure to perform this
step could make the treatment less effective.
The pre-treatment liquid does not require stirring after
the package is opened.
A
Place the package on a level surface with the tap
cover on the side.
B
Rotate the package clockwise five times.
Rotate the package at a speed of one revolution
every two seconds.
– Polyester Pre-treatment Liquid (T43R2) –
C
D
E
3
Rotate the package counterclockwise five times.
Rotate the package at a speed of one revolution
every two seconds.
Rotate the package clockwise five times.
Rotate the package at a speed of one revolution
every two seconds.
Rotate the package so that the tap cover is on top.