To An S Video Equipped Vcr - Sony KL-X9200J Bedienungsanleitung

Connecting to video equipment
To a VCR not equipped with an S video
connector
Rear of the monitor
VIDEO IN
1
S VIDEO
to VIDEO 1 IN or
VIDEO
VIDEO 3 IN
L
AUDIO
R
VMC-810S/820S
(not supplied)
VCR
You can also use the VIDEO 2 IN jacks on the front of
the monitor for the video/audio connections.

To an S video equipped VCR

Rear of the monitor
VIDEO IN
1
S VIDEO
to VIDEO 1 IN or
VIDEO 3 IN
VIDEO
L
AUDIO
R
YC-810S
(not supplied)
VCR
VIDEO
COMPONENT IN
3
OUT
Y
P /C /B-Y
B B
P /C /R-Y
R R
L
AUDIO
R
to video/audio outputs
VIDEO
COMPONENT IN
3
OUT
Y
P /C /B-Y
B B
P /C /R-Y
R R
L
AUDIO
R
to S video/audio outputs
Notes
• You can also use the S VIDEO connector on the VIDEO 2 IN
panel on the front of the monitor.
• When you connect the cable to both the VIDEO jack and the S
VIDEO connector, the picture from the S VIDEO connector is
displayed on the monitor screen.
Connecting two VCRs for editing
The monitor outputs the signal input from the VIDEO 1
IN, VIDEO 2 IN or VIDEO 3 IN jacks through the
VIDEO OUT jacks. With two VCRs connected to the
VIDEO IN and VIDEO OUT jacks, you can edit a tape.
Notes
• Signals input from the RGB 1 IN, RGB 2 IN and COMPONENT
IN connectors are not output through the VIDEO OUT jacks.
• Do not connect both the VIDEO IN and VIDEO OUT jacks on
this monitor simultaneously to the video/audio output and
input jacks on a single VCR.
• If no signal is input to the S VIDEO connector on any of the
VIDEO 1, 2 and 3 IN panels, the S VIDEO connector on the
VIDEO OUT panel does not output a signal.
Rear of the monitor
VIDEO IN
1
S VIDEO
to VIDEO 1 IN
VIDEO
or VIDEO 3 IN
L
AUDIO
R
VMC-810S/820S
(not supplied)
to video/audio
outputs
VCR for playback
VIDEO
3
OUT
to VIDEO OUT
VMC-810S/820S
(not supplied)
to video/
audio
inputs
VCR for recording
11 -GB
Getting Started
GB