Adjusting The Computer Picture - Sony KL-X9200J Bedienungsanleitung

To turn off the monitor
Press 1/u on the remote control. The monitor enters
standby mode and the STANDBY indicator lights up.
To turn off the main power, press u switch on the
monitor.
Note
To protect the lamp, the picture and sound will not turn on
immediately if you try to turn on the power more than 5 seconds
after the power has been turned off. If you turn the monitor back
on within about 5 seconds after power-off, the picture and sound
will reappear immediately.
Muting the sound
Press MUTING on the remote control.
"MUTING" appears on the screen.
To restore the sound, press MUTING again, or press
VOL+.
Displaying on-screen information
Press DISPLAY on the remote control to display the
following information on the screen.
Current input
RGB 1
signal
fH: 37.5kHz
fV: 75Hz
*fH: Horizontal frequency
fV: Vertical frequency
"OUT OF SCAN RANGE" appears if the scanning
frequency range is not within the acceptable
limits. (See page 9.)
To make the on-screen information disappear, press
DISPLAY again.
16 -GB
Operations
Adjusting the
computer picture
Adjusting the position (CENTER)
After projecting the picture from a computer, you may
need to adjust the position of the picture to fit the
monitor screen. You can also move the picture as you
like. The setting is only for the input signal displayed
on the screen.
1
Current input signal
frequency when
the RGB signal* is
input
2
3
MENU ENTER
Press MENU.
MENU
Press v or V to select "
press ENTER.
ENTER
Press v, V, B or b to adjust the position.
For horizontal adjustment press B or b.
b: to move the picture right
B: to move the picture left
For vertical adjustment press v or V.
V: to move the picture up
v: to move the picture down
(CENTER)," and
C E N T E R
EX I T