Alarms - Dalla Corte dc two Benutzerhandbuch

Alarms

This coffee grinder has an electronic control that
checks and signals the presence of possible ano-
malies due to internal failures or to incorrect use.
ALARM
Data loss
Blocked burr
Broken serial line
Triac board not working
Low tension
Wattmeter alarm
Burr cleaning
High internal temperature
High coffee temperature
Gearmotor power
Broken hall sensor
Broken NTC probe
Broken pt1000 probe
Open safety screw
42
Burr replacement
CAUSE
Big interference on the electric
network
Big impurities in coffee
Coffee machine is switched off
or serial cord is unplugged
Failure in grinding motor
Problems with power supply tension
Cleaning cycle needed
Motor is overheated and/or air
cooling is blocked
Worn out burrs
Gearmotor for grind adjustment
is blocked
Sensor of burrs position is broken
Motor temperature sensor is broken
Coffee temperature sensor
is broken
Bean hopper safety screw button
is open
Maximum number of doses reached
in counters
Some of the alarms are designed to signal possible
failures, others to lock the coffee grinder.
In case an alarm is triggered, do as follows:
SOLUTION
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Try the burr cleaning cycle.
If the problem persists, please contact
an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Carry out the burr cleaning cycle
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Switch off the grinder, switch it back on
to go on with your work.
Contact an authorized Technical Service
Check the bean hopper is in place.
If the problem persists, please contact
an authorized Technical Service
Contact the Technical Service