Checking For Sound; About Adaptiq Audio Calibration; Running Adaptiq® Audio Calibration - Bose VIRTUALLY INVISIBLE 300 Bedienungsanleitung

F I N I S H I N G S E T U P

Checking for sound

1. Power on your TV.
2. If you are using a cable/satellite box or other secondary source:
• Power on this source.
• If your secondary source is connected to your TV, select the appropriate TV input.
If you have not programmed the SoundTouch® 300 remote control, you may need
to use a different remote.
3. Power on the SoundTouch® 300 soundbar.
You hear sound coming from your rear speakers.
Note: If you do not hear sound from the rear speakers, see "Troubleshooting"
on page 17. If you do not hear sound from your soundbar, refer to the
SoundTouch® 300 owner's guide.
About ADAPTiQ
After connecting your rear speakers to the SoundTouch® 300 soundbar, run ADAPTiQ®
audio calibration for the best acoustic performance. ADAPTiQ customizes the sound of
the system to the acoustics of your listening area by taking five audio measurements. To
run an audio calibration, you need 10 minutes when the room is quiet.
During ADAPTiQ, a microphone on the top of the ADAPTiQ headset (provided with the
SoundTouch® 300 soundbar) measures the sound characteristics of your room to
determine optimal sound quality.
If you no longer have the ADAPTiQ headset, contact Bose® customer service for a
replacement.
Note: If you are also pairing the Acoustimass® 300 wireless bass module with the
soundbar, pair the bass module before running ADAPTiQ audio calibration. Refer
to the Acoustimass® 300 quick start guide or owner's guide.
Running ADAPTiQ® audio calibration
1. Insert the ADAPTiQ® headset cable into the ADAPTiQ connector on the back of
the soundbar.
1 2 - E N G L I S H
audio calibration
®