Fujitsu Airstage UTY-CGG Bedienungsanleitung Seite 6

WEEKLY TIMER
G Timer setting
4
Decrement Increment
G Operating setting
5
Raise
Lower
G Setting the next timer for the same day:
6
Then press the ENTER button to proceed to the time setting, and repeat steps from
G Repeat steps
Be careful for pressing the ENTER button without any operation setting because the time that is set will be
cancelled.
G Setting the timer for the other indoor units:
7
8
1. Press the ENTER button to confirm the set timer.
2. Press again the PROGRAM (CLOCK ADJUST)
button to complete the weekly timer setting.
* flashes for two seconds.
G To delete the operating time
En-5
Press the Set Time buttons to set the time in 10-minute increments.
* Hold down a Set Time button to adjust the time quickly.
Press the Start/Stop button or the Mode button or the Set Temperature button to set
the operation.
* For the operations that can be set, refer to "Operation mode setting", "Room tem-
perature setting" (page 3), and "To start/stop operation" (page 4), in "OPERATION".
* Only the current operation settings are displayed.
AM
ex. TIMER-1 will start operation at 8:00 on COOL.
TIMER-1
3 5
to to set the timer for another day of the week.
Before setting the timer for other indoor units, press the ENTER button to confirm the
settings.
* The display switches to the next timer.
G Repeat steps
CLOCK ADJUST
1. If the Timer Mode (DELETE) button is pressed during steps
ing time for the selected day will be deleted.
* If all the days are selected, the operating times for all of the days of the se-
lected timer will be deleted.
2. Press the ENTER button to confirm the deletion.
TIMER-2
2 6
to to set the timer for other indoor units.
When the operating time is set, the
AM
ex. TIMER-1 will start operation at 8:00 on COOL with a set-
ting of 20 °C.
TIMER-3 TIMER-4
4 5
to .
mark appears.
3
to
7
, the operat-