Preparation; Operation - Fujitsu Airstage UTY-CGG Bedienungsanleitung

PREPARATION

To set the current day and time
1
CLOCK ADJUST
Hold down the PROGRAM (CLOCK ADJUST) button for
2 seconds or more.
3
Decrement Increment
Press the Set Time buttons to set the current time.
Press repeatedly to adjust the current time in 1-minute increments. Press and
hold to adjust the current time in 10-minute increments.
* Hold down a Set Time button to adjust the time quickly.

OPERATION

G It is possible to make the operation settings for all indoor units or individual units.
To select the indoor unit
Press the Select button to select the indoor unit.
The
* If all indoor units are selected, all of the registered indoor units are controlled at the same time.
* If all indoor units are selected,
To set the operation mode
G Operation mode setting
G Room temperature setting
Raise
Lower
En-3
AM
ex. Monday 10:00 (12-hour display)
1st indoor unit 2nd indoor unit
for the selected indoor unit lights, and the operating status is displayed.
Press the Mode button to set the operation mode.
*
AUTO COOL
* AUTO cannot be selected for a heat pump model unless it is set up as an Administrative indoor unit.
** FAN cannot be selected for a heat pump model.
*** HEAT cannot be selected for a cooling only model.
Refer to details in the Administrative indoor unit OPERATING TIPS.
* If the priority mode is set to "Priority on Control Indoor Unit", the operating mode of
other indoor units except Control Indoor Unit will be controlled by a Control Indoor Unit.
* If the operating mode of Administrative Indoor Unit is set to "AUTO", "AUTO" is
displayed in addition to the display of current operating mode on other wired remote
controllers except Administrative Indoor Unit. In this case, operation of other indoor
units is controlled by the Administrative Indoor Unit.
Example: When operating mode of the Adminis-
trative Indoor Unit is set to "AUTO" while
air conditioning setting. (The indication
on other wired remote controllers except
Administrative Control Indoor Unit).
Press the Set Temperature buttons to set the room temperature.
Temperature setting range
AUTO ............................................................ 18 to 30 °C (64 to 88 °F)
COOL/DRY .................................................... 18 to 30 °C (64 to 88 °F)
HEAT ............................................................. 10 to 30 °C (48 to 88 °F)
The set temperature cannot be set during the FAN mode.
(The temperature will not appear on the remote controller's display.)
* According to the initial setting, the heating temperature range from 10 to 15 °C (48
to 58 °F) cannot be set. In addition, the temperature range from 10 to 15 °C (48 to
58 °F) is invalid depending on the model even if it can be set.
2
DAY
S M
SUN MON
8th indoor unit
appears on the Timer and Clock Display.
**
DRY FAN HEAT
Press the DAY button and select the
current day.
A appears around the selected
day.
T W T F
TUE WED THU FRI
4
CLOCK ADJUST
Press again the PROGRAM (CLOCK
ADJUST) button to end.
All indoor units
***
When Administra-
tive Indoor Unit is
set to "AUTO".
S
SAT