Dometic RM122 Montage- Und Bedienungsanleitung Seite 19

RM122, RM123
8.3 Connecting to 230 Vw (RM123 only)
!
WARNING!
The electrical installation must only be connected by a qualified
electrician in accordance with national regulations. Improper con-
nection can cause serious danger.
The device is connected to a 230-Vw power outlet via a power plug.
The connecting cable is delivered without a power plug. A suitable power
plug may only be connected by a specialist. The power plug must fit the
power outlet in your vehicle and comply with the legal requirements in your
country.
If necessary, have an appropriate power plug installed at a suitable place.
The mains socket must be easily accessible so that you can unplug the
power plug if necessary, and thus the device can be disconnected from the
mains.
The cable wiring is as follows:
 Green and yellow: Earth (fig. d 1, page 6)
 Blue: Neutral (fig. d 2, page 6)
 Brown: Phase (fig. d 3, page 6)
8.4 Connecting to a gas source
A
NOTICE!
 The device may only be connected by a qualified electrician in
accordance with applicable regulations and standards to the
gas supply.
 Only use cylinders of propane or butane gas (not natural gas)
with an approved pressure reduction valve and suitable top
part. Compare the pressure specifications on the nameplate
with the pressure indication on the propane or butane gas bot-
tle.
 The device may only be operated at the pressure indicated on
the nameplate.
 Please note the pressures which are permitted in your coun-
try.Use a DIN-DVGW-approved pressure regulator with a fixed
setting in accordance with DIN EN 12864.
 Note the norms EN 732 and EN 1949.
EN
Connecting the refrigerator
19