Operation; Product Overview - Toro 1800 Power Curve Bedienungsanleitung

Operation

Product Overview

1. Rotor blades
2. Belt cover (not shown)
3. Chute deflector
4. Chute deflector trigger
5. Discharge chute handle
6. Cord lock
7. Interlock button (key)
Important:
This machine is intended for outdoor,
residential use only. Do not use it indoors or for commercial
or industrial purposes.
Connecting to a Power
Source
The power supply you use with this appliance should be a
residential current device (RCD) with a tripping current of not
more than 30 mA. Use only a CE approved extension cord
recommended for outdoor use. Do not change the appliance or
extension cord plug in any way.
DANGER
Contact with water while operating the machine could
cause electric shock, causing injury or death.
•
Do not handle the plug or the machine with wet
hands or while standing in water.
•
Use only an extension cord recommended for
outdoor cold-weather use.
Figure 8
8. Power control bar
9. Upper handle
10. Cord
11. Chute control rod
12. Handle knobs
13. Discharge chute
Extension Cord Length
Up to 20 m
20 to 40 m
Important:
Check the extension cord frequently during
use for holes or cracks in the insulation. Do not use a
damaged cord. Do not run the cord through standing water.
Note:
To prevent the extension cord from disconnecting during
operation, use the cord lock on the upper handle before you
connect it to the machine
g220753
1. Cord lock
WARNING
The electrical cord can get damaged, causing a shock
or fire.
Thoroughly inspect the electrical cord before using the
snowthrower. If the cord is damaged, do not operate
the snowthrower. Repair or replace the damaged cord
immediately. Contact an Authorized Service Dealer for
assistance.
Starting and Stopping the
Motor
1. To start the motor, insert the interlock button (key), press
and hold the interlock button (key), and squeeze the power
control bar to the handle
6
Minimum Wire Gauge
3 x 1.5 mm²
3 x 2.5 mm²
(Figure 9).
Figure 9
2. Extension cord
(Figure 10).
g220754