Double-Insulated Appliances; Product Information - Toro 1800 Power Curve Bedienungsanleitung

1. Screws
2. Remove and discard the old scraper.
3. Install the new scraper, and fasten it securely with the 4
screws that you previously removed.
Replacing the Rotor
1. Remove the screws that secure the right side plate to the
machine frame (Figure
2. Remove the rotor pin
1. Rotor pin
Figure 14
15).
Figure 15
(Figure 16).
Figure 16
3. Remove the old rotor.
4. Install the new rotor by inserting the end of the rotor onto the
fitted end in the housing and rotating the rotor until it snaps
into place (Figure
g013469
1. Fitted end of the rotor
Note:
Ensure that the nut that secures the rotor pin
remains inside the recessed hole in the right inside wall of
the housing.
Note:
The housing will flex when you install the rotor.
5. Tighten the bolt on the side of the housing.
6. Install the right side plate with the screws that you removed
in step 1.
Service
Toro has designed this machine to give you years of trouble-free
use. Should it need service, bring the machine to an Authorized
g013463
Service Dealer.
Double-insulated
Appliances
In a double-insulated appliance, two systems of insulation
are provided instead of grounding. No grounding means
is provided on a double-insulated appliance, nor should a
means for grounding be added to the appliance. Servicing a
double-insulated appliance requires extreme care and knowledge
of the system, and should be done only by the qualified service
personnel at an Authorized Service Dealer. Replacement parts for
a double-insulated appliance must be identical to the parts they
replace. A double-insulated appliance is marked with the words
"Double Insulation" or "Double Insulated." The symbol (square
within a square)

Product Information

g013464
A model and serial number decal is located on the housing.
Always refer to specific numbers on the decal in correspondence
or when you need replacement parts.
9
17).
Figure 17
may also be marked on the appliance.
g013465