Toro 1800 Power Curve Bedienungsanleitung Seite 8

Figure 10
1. Interlock button (key)
Note:
You may release the interlock button (key) after you
squeeze and hold the power control bar to the handle.
2. To stop the motor, release the power control bar.
Note:
When you stop the machine after you have finished
removing the snow, also remove the interlock button (key)
and disconnect the extension cord.
g017930
2. Power control bar
Adjusting the Discharge
Chute and Chute Deflector
To adjust the discharge chute, move the handle on the chute
control rod in the direction that you wish to direct the snow stream
(Figure 6 and Figure 7).
To adjust the chute deflector (and therefore the height of the snow
stream), squeeze the trigger and raise or lower the chute deflector
(Figure 11).
1. Chute deflector trigger
WARNING
A gap between the discharge chute and the chute
deflector may allow the machine to throw snow and
objects toward you or bystanders. Thrown objects
could cause serious personal injury.
•
Do not force the chute deflector too far forward so
that a gap appears between the discharge chute
and chute deflector.
•
Do not adjust the chute deflector with the power
control bar engaged. Release the power control bar
before adjusting the chute deflector.
7
Figure 11
g013461