Ikra IPHT2660 Originalbetriebsanleitung Seite 31

FAILURE REMOVAL
Problem Check
Fuel at the carburetor
Fuel at the cylinder
The engine stalls, is
difficult to start or
does not start
Sparks at the spark plug
electrodes
Sparks at the spark plug
Air filter
Fuel filter
Fuel vent
Spark plug
The engine turns,
but stalls or does not
Carburetor
accelerate correctly
Cooling system
Spark suppressor
The engine does not N/A
engage
Condition Causes
Fuel filter blocked
The fuel does
Fuel supply blocked
not arrive at the
carburetor
Carburetor
The fuel does not Carburetor
arrive at the cylinder
The fuel mixture is too rich
There is fuel in the
exhaust
Switch in off position
There is no spark Electrical problem
Locked switch
Bad spacing of the electrodes
Electrodes contaminated
There is no spark
Electrodes contaminated
with fuel
Defective spark plug
Dirty air filter Fair wear and tear
Dirty air filter Dirt or residue in the fuel
Blocked fuel vent Dirt or residue in the fuel
Dirty or worn spark Fair wear and tear
plug
Bad adjustment Vibration
Excessive Prolonged use in dirty or dusty
places
Plate cracked, Fair wear and tear
contaminated or
perforated
N/A Internal engine problem
EN ENGLISH
Solution
Clean or replace
Clean or replace
Ask your distributor for advice
Ask your distributor for advice
Open the throttle valve
Luftfilter reinigen oder
austauschen
Adjust the carburetor
Ask your distributor for advice
Set the switch to the ON
position (Run)
Ask your distributor for advice
Ask your distributor for advice
Adjust the gap to 0,6-0,7 mm
Clean or replace
Clean or replace
Replace the spark plug
Clean or replace
Replace
Clean or replace
Clean, adjust or replace
Adjust
Clean
Replace
Ask your distributor for advice
29