Beha-Amprobe AT-6000-EUR Bedienungsanleitung Seite 8

2. KIT COMPONENTS
VOLUME
ADJUSTMENT
BUTTON (+/-)
FUNCTION/MODE
BUTTON
Toggles between modes:
- Quick Scan mode
- Precision Tracing mode
- Breaker/Fuse mode
- Non-contact-voltage
(NCV) detection
mode, passive tracing
ON/OFF: Short press to turn the receiver on. Long press >2s to turn the receiver off.
VOLUME ADJUSTMENT: The volume can be changed by short presses on VOLUME UP/ DOWN
buttons. The mute and four loudness level are available. The chosen volume level will be
shown on the display.
TIP SENSOR LED: This LED is blinking when signal is detected. The stronger the signal, as
faster is the blinking.
FUNCTION/MODE: This button toggles between the different modes:
- Quick Scan mode (tracing energized + de-energized wires)
- Precision Tracing mode (tracing energized + de-energized wires)
- Breaker/Fuse mode (tracing energized + de-energized fuses)
- Non-contact-voltage (NCV) detection mode, passive tracing
SENSETIVITY: This button is to adjust the sensitivity of the receiver. Eight levels are available.
NCV
Figure 2.1a: Overview of AT-6000-RE Receiver
TIP SENSOR
TIP SENSOR LED
LC-DISPLAY
Full color TFT display
RUBBER OVERMOLDED
ENCLOSURE
SENSITIVITY ADJUSTMENT
BUTTON (-/+)
POWER BUTTON
Turns unit On / Off
BATTERY COMPARTMENT
(Back side)
HOT STICK ATTACHMENT POINT
(Do not use for voltage higher
than 600V)
6