Beha-Amprobe AT-6000-EUR Bedienungsanleitung Seite 30

5. MAINTENANCE
Changing AT-6000-RE battery:
The battery compartment on the back of the AT-6000-RE is designed to make changing
batteries easy. Four (4) AA 1.5V alkaline or 1.2V rechargeable batteries may be used.
1. Make sure that the AT-6000-RE is turned off.
2. Use screw driver to unscrew the captive screw.
3. Remove the battery cover.
4. Install batteries.
5. Replace the battery cover and secure it with the provided screw.
* AT-6000-RE automatically recognizes if batteries are Alkaline or Rechargeable and adapts
the battery indication to provide the right information.
If you are using rechargeable batteries that are old, or with some alkaline batteries,
the battery indication may not be good. If this happens, procede with these override
procedures:
- If user turns the device on while holding the volume + button, the device will
automatically adjust battery indication for Alkaline batteries.
- If user turns the device on while holding the volume - button, the device will
automatically adjust battery indication for Rechargeable batteries.
Figure 5.0b: Changing receiver battery
28