Bartscher K7ECI05VV Bedienungsanleitung Seite 42

The parts in steel can be cleaned with warm water and neutral detergent, using a cloth; the detergent
must be suitable for cleaning stainless steel and must not contain abrasive or corrosive substances.
Do not use common steel wool or anything similar which, depositing iron particles, could cause rust
from it. It is also better to avoid using sandpaper or emery paper. Only in the event of encrusted
dirt, pumice stone in powder may be used but an abrasive synthetic sponge or stainless steel wool
would be preferable, to be used in the direction of the grain. After washing, dry with a soft cloth.
To clean the oven, remove the wire grill, the bottom, the top diffuser (in the electric oven), the grill
holder and clean them with warm water, neutral detergent and an appropriate utensil, rinse and dry
well. Finally, put back all the components, being careful to fit them properly into place.
The cleaning mode of the glass ceramic is the same of the glass. Do not use any corrosive detergent,
as oven sprays, iron wool or cleaning dust.
Before the cleaning, the glass ceramic surface must be left cooling.
Any detergent residue must be clean off from the cooking zone with a wet tissue since with the heat
they could give a corrosive reaction.
Suggestions related to the cleaning of the glass ceramic:
Type of dirty
Light dirty without any dry residue
Spots of grease (sauces, soups, oil)
Sticky dirty
Calcar and water residues
Sugar, food, plastic or aluminium crusts.
ATTENTION: let the cooking surface cooling before cleaning
If the appliance is out of use for a long time, it is advisable to disconnect the main electricity supply
and wipe all stainless steel surfaces with a cloth soaked in vaseline oil in order to give it a protective
film and air the rooms now and again.
Maintenance
ATTENTION! Before doing any kind of maintenance or repairs, make sure that the
appliance is disconnected from the electric mains.
The following maintenance operations must be carried out at least once a year by specialized
personnel. It is advisable to have a maintenance contract.
x Check for correct functioning of all control and safety devices;
x Check the condition of the power cable;
x Clean the filter in non-woven fabric placed at the air entry of the fan, wash it carefully to
remove possible residues of dirt, rinse it, to dry it and place it at the same position.
Suitable material of cleaning.
Wet tissue.
Clean with a non-abrasive detergent
Non-abrasive detergent and clean with a wet tissue
Clean off with vinegar, creamy detergent and clean
carefully with a wet tissue.
Scrape on the spot with a scraper (razor blade), clean
with a creamy detergent and than again with a wet
cloth. If the area should cool down with this kind of
dirty the glass ceramic could deteriorate.
Pag. 41/68