MTD GCS 50 Bedienungsanleitung Seite 50

GB
1) Take off the cap and loosen the plug using the
wrench provided (fig. 22).
Check and possibly adjust the distance between
the electrodes (fig. 21).
If the electrodes are excessively soiled or are very
worn, replace the spark plug with an equivalent
one (fig. 21).
Excessive soiling may be due to:
# The oil ratio used in fuel is too high and/or oil is
not of an appropriate type.
# Air filter is partly clogged.
2) Screw the spark plug manually as far as pos-
sible to avoid damaging its socket. Use the wrench
provided only to tighten it (fig.20).
3) Do not carry out repairs on the machine (if you
are not qualified to do so). Contact an authorised
service centre.
DANGER! In order to maintain the
original safety features, do not make any
changes to the machine.
In case of repairs, only use genuine spare
parts.
An improper mantainance, use of non original
components, the removal and/or damage of
the safety devices can be very dangerous,
even mortal (see chapter B : "SAFETY DE-
VICES").
50
CHAIN SAW OPERATING MANUAL
9.7 CHECKING SCREWS, FIXED PARTS AND
MOVING PARTS.
# Before each use, please make sure there are
no loose or damaged screws / parts and that the
bar and chain are not significantly worn.
# Replace the damaged parts at an authorised
service centre before using the machine.
9.8 CLEANING, TRANSPORT AND STORAGE
# If the hedgecutter must be transported or is
not used for long periods of time, empty the fuel
tank.
# Do not clean with aggressive liquids.
# Store the machine in a dry and safe place inac-
cessible to children.
# Before transporting or storing the chainsaw,
protect the bar/chain with the guard supplied.