Mounting The Bar And Chain; Refuelling - MTD GCS 50 Bedienungsanleitung

4. MOUNTING THE BAR AND
CHAIN
WARNING! DO NOT START THE
CHAINSAW BEFORE YOU HAVE MOUNTED
AND ADJUSTED THE BAR AND CHAIN.
WEAR SAFETY GLOVES WHEN PER
FORMING THIS OPERATION. THE
CUTTING TEETH (OF THE CHAIN) CAN CAUSE
WOUNDS
1) Open the box containing the chainsaw and
extract the disassembled parts and accessories
as shown in Fig.2. In the box you will find:
part.1 – Chainsaw body
part.2 – Chain guide bar
part.3 - Chain
part.4 – Combination spanner.
part 5 – Chain adjustment screwdriver.
part 6 – Bar cover.
part 7 – Instruction manual.
2) Position the Chainsaw body as in Fig. 3 and
make sure that the (chain) safety brake is not
ingaged (arrow Fig.3).
3) Unscrew the nuts (Fig.4 part.1) and remove
the chain cover.
4) Remove the plastic or cardboard shim (fig.4
item 2) located between the chain brake cover
and the guide bar connecting plate. This shim is
provided to hold in position the chain brake cover
during transport.
Therefore, it must NOT be used!
5) Rotate the chain tensioning screw anticlockwise
(unscrew direction) (Fig.5 part.1) so that the chain
tensioning tooth retreats (Fig.5 part.2).
6) Fit the chain around the drive sproket (fig 6).
The teeth of the top part must be oriented as
shown in the diagram.
CHAIN SAW OPERATING MANUAL
ATTENTION !! Make sure to match the chain teeth
correctly with the corresponding sprocket teeth.
7) Position the chain guide bar on the stud bolts
(Fig.7).
8) Insert the chain guide teeth into the groove of
the bar (Fig.8). Pull the bar in such a way as to
stretch the chain. 3). Align the chain tension tooth
"X" to the guide bar hole.
9) Slightly screw up (clockwise) the chain tension
screw to achieve initial light tension (fig. 9).
10) Fit the chain cover back on and tighten the
nuts by hand.
11) Complete chain tensioning by screwing up
(clockwise) the chain tension screw (fig. 9).
When the proper tension has been reached, the
chain can be raised with two fingers to the point
where an entire guide tooth is visible (Fig.9 part.
A).
12) Fully tighten the two nuts with the key provided
(Fig.10) keeping the point of the bar raised. Check
that the chain can run freely in the bar.
NOTE!! The tension of a new chain must be
checked and set (with the engine off and the brake
on) after a few minutes of work.

5. REFUELLING

1) ATTENTION! The equip-
ment is provided with a
2-stroke engine.
The engine requires a mixture of petrol and oil for
2-stroke engines with the following percentages.
40:1 = (2,5% oil)
PETROL: use unleaded petrol with octane
number equal / higher than 95 Ron.
GB
43