EKOM DK50-10 series Handbuch Seite 31

Never use the safety valve to vent air pressure in the air tank. It could damage the
safety valve. The valve is set to the maximum permitted pressure by the
manufacturer. Adjustments are not permitted!
WARNING! COMPRESSED AIR CAN BE DANGEROUS. WEAR EYE PROTECTION
WHEN VENTING ANY AIR. COMPRESSED AIR MAY DAMAGE THE EYES OR
CAUSE VISION PROBLEMS.
Inlet filter replacement
(Fig. 12)
 Pull out the rubber plug (2) by hand.
 Remove the used filter (1).
 Insert a new filter and replace the rubber plug
Filter element replacement
(Fig. 13)
 Remove the hose (1) from the quick connector.
 Use a wrench (2) to release the filter vessel (3) and remove.
 Pull down on the filter element (4) to remove.
 Insert a new filter element.
 Re-install the filter vessel.
 Gently tighten the filter vessel with the wrench.
 Re-install the hose on the quick connector.
Fig. 13
1
Cooler and fan check (Fig.2)
The equipment altogether, and especially the compressor fan, cooler fan (21) and cooler (14), must
be kept clean to ensure efficient drying performance; vacuum or blow down the cooling fins and fans
with compressed air to remove any dust from the surface.
Jumper connections
It may be necessary to start the cabinet-mounted compressors outside of the cabinet for service
purposes. This means starting the compressor without the cabinet connector attached. To start the
compressor, a jumper must be installed in the electrical box.
NP-DK50-10-7_05-2019-MD
Fig. 12
3
2
- 30 -
DK50-10
1
2
4
05/2019