CO/Tech ZHQ1821SH-ADCA Bedienungsanleitung Seite 4

Assembly
1. Screw the end of the lower tube into
the hole in the base.
3. Connect the two middle tubes
to the lower tube by screwing
them together.
4. Feed the mains lead through all
the tubes.
5. Connect the mains lead to the power
socket on the heater head.
6. Push the heater
head onto the upper
tube and fasten
it using the two
included screws.
2. Feed approximately 2 m of
the mains lead through the hole
in the base.
4