Connection With The Mains - EuroLite DPX-1210 Bedienungsanleitung

Occupation of the XLR connection:
If you are using controllers with this occupation, you can connect the DMX output of the controller directly
with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other
XLR outputs, you need to use adapter-cables.
Building a serial DMX chain:
Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Caution: At the last device, the DMX cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR plug and plug it in the DMX output of the last device.
Addressing
For setting the DMX address see chapter operation.

6.4 Connection with the mains

The electric connection must only be carried out by a qualified electrician!
In order to connect the device to the mains, you have to install a power supply cable and a power plug. The
occupation of the connections is as follows:
Cable Pin
Black Live1
Brown Live2
Grey Live3
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Connect the device to the mains with the power plug.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
DANGER TO LIFE!
International
L1
L2
L3
N
20/24
resistor
00051009.DOC, Version 1.4