Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. INSTALLATION
Install the device on a plane surface or install it in a rack.
5.1 Rack installation
This device is built for 19" racks (483 mm). The rack you use should be a double-door rack where you can
open the front panel and the rear panel. The rack should be provided with a cooling fan. When mounting the
device into the rack, please make sure that there is enough space around the device so that the heated air
can be passed on. Steady overheating will damage your device. You can fix the device with four screws M6
in the rack.
6. CONNECTIONS
6.1 Analog input
The analog input allows connecting an analog light controller with 0 . 10 V control voltage. The occupation of
the 15-pin Sub-D socket is as follows:
1. Channel 1
2. Channel 2
3. Channel 3
4. Channel 4
5. Channel 5
6.2 Connecting the lamps
Connect your loads via the pole connectors behind the blind plate. The maximum load per channel is
2300 W. Please note that the maximum current of 120 A must never be exceeded!
6.3 Connection to the DMX512 controller / connection between fixtures
The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR plugs and connectors in order to connect the controller with
the device or one device with another.
6. Channel 6
7. Channel 7
8. Channel 8
9. Channel 9
10. Channel 10
Unplug mains lead before connecting lamps!
the devices will not work at all, or will not work properly.
11. Channel 11
12. Channel 12
13. Not connected
14. Not connected
15. Ground
CAUTION!
19/24
00051009.DOC, Version 1.4
Werbung
Inhaltsverzeichnis
