Self Learning Feature - CAMPAGNOLO ErgoBrain 10 Bedienungsanleitung

Self Learning Feature

When CDC sensor is attached to your bike, the ErgoBrain10 automati-
cally calculates the number of teeth of your sprockets. (This is why you did
not have to input the sprockets' teeth in Page 7.) This is called Self Learn-
ing feature.
Even when the wheel is changed during a race, you only need to do the
updating operation (as the explanation below) and the unit continues self-
learning without loss of any data.
You also need to do the updating operation when you have changed the
sprockets (cog set).
Updating *
Danger !
• When riding, always remain aware of your surroundings. Do
not give excessive attention to the data displayed. Maintain
your focus on the road, traffic conditions, obstacles, etc.
Updating should be done while riding your bicycle. You can start the updating
with any chain position, but be sure that chain is not skidding but in secure
position and the crank is rotating firmly. In any measuring modes, hold down
S/S button for more than two seconds, and the unit starts updating.
Starts updating
Note: The unit takes about five seconds, depending on the riding speed,
to calculate the number of teeth of each sprocket. While calculat-
ing, the wheel icon flashes.
Immediately after starting the updating process, the unit might show in-
correct teeth numbers, but the system will be instantaneously calibrated
and recalculated to the correct numbers.
* If CDC sensor is not attached, the self learning feature does not work.
2sec.
S/S
Updating
- 17
UK