CAMPAGNOLO ErgoBrain 10 Bedienungsanleitung Seite 36

Time Functions (Training Screen)
In these functions, you can set your desired length of Effort Time (exercis-
ing period) or Recovery Time (resting period).
Set Time Beeper or Time+Cadence Beeper on, and STW screen changes
into Training Screen. Push S/S button to start theTime Functions. The timer
continues to count down Effort Time (exercising period) and Recovery Time
(resting period) alternately. When the screen shifts between Effort Time to
Recovery time, beep blows.
Push S/S button again to stop. Unless you push S/S button or your bike
ceases to move, the timer continues counting down.
During the last 5 seconds of the Recovery Time and for the first 5 seconds
of the Effort Time, the screen shows how many training cycles you have
been through. When the speed becomes zero, the timer stops counting.
Push S/S button to restart the Time Functions.
The computer beeps only when the display is showing Training Screen.
When it is showing Auto Timer screen, the computer does not beep but the
timer continues counting down.
Note: When the screen is showing the number of training cycles you have
reached, cadence beeper remains silent.
How to reset the number of training cycles
Reset it when the screen shows Training Screen. This operation does not
reset the data obtained in Auto Timer screen.
AUTO TIMER
SCREEN
MODE button
MODE
Hold down for two seconds
Just push
Reset operation
AT / STW and TRAINING
S/S MODE
are reset independently
TRAINING SCREEN
E:
Effort Time
Range: 0.5 – 99.0 minutes
(in 0.5minutes steps)
When timer starts: short beep
Cadence
Repeat
Current
Speed
Repeat
R:
Recovery Time
Range: 0.5 – 99.0 minutes
(in 0.5minutes steps)
When timer starts: long beep
Beeper
Beeper
- 15
UK