Format/Initialization; Press Ac Button; Select Speed Scale - CAMPAGNOLO ErgoBrain 10 Bedienungsanleitung

Format/Initialization

When you use the ErgoBrain10 for the first time, or
after you have replaced the battery, you need to format
the unit. Before doing this, find out your front wheel's
circumference.
Note: From the second time, formatting can be sim-
plified. A press of AC button will retain the
former data such as the wheel circumference and information on
chainring/sprocket, so just press SET button in each process of for-
matting. Only for the setting of chainring shift timing, you need to
press S/S button.

1. Press AC button.

Note: While holding down SET button, press and release AC button. All
display goes on for one second and then it changes to the scale selec-
tion screen. Then release SET button. With this operation all the data
are erased and the unit is initialized (EEPROM returns to its default
state). Perform this operation only when you need to reset the odometer
to zero. By initialization, all the former data such as the wheel circum-
ference and information on chainring/sprocket is erased and returns to
the default state.
1
To the next step

2. Select speed scale.

Push MODE button to switch between [KMH] and [MPH]. Push SET
button to decide.
2
To the next step
- 4
UK
AC
Format
All displays illuminate (1 sec.)
Switch between [KMH] and [MPH].
MODE
SET
SET AC
Initialization of
EEPROM
(See the "Note" above)
L