Select 9S Or 10S Sprockets; Input Sprocket's (Cog Set's) Number Of Teeth - CAMPAGNOLO ErgoBrain 10 Bedienungsanleitung

7. Select 9s or 10s sprockets.

Note: Depending on your chainring setting, this process may be skipped.
Select the number of sprocket (9 or 10) by the push of MODE button.
Push SET button to fix.

8. Input sprocket's (cog set's) number of teeth.

Note: This process is skipped if you have selected CDC sensor [ON].
Select the number of teeth from the preset combinations of the cog set.
If your sprockets' combination is not included in these cog sets combi-
nation, select [FREE] and you can input all the sprockets manually.
Note: Sprocket setting should be done individually for wheel A and wheel
B. First, input wheel A's sprocket, and hold down SET button.
The screen moves to wheel B's sprocket setting. Repeat the same
procedure for wheel B.
7
If CDC
sensor
is ON
8
Input sprocket's
(cog set's)
number of teeth
SET
Select from 7 types
of combinations
9
To the Process
MODE
SET
10speed cog set
COG 11-21
COG 11-23
COG 12-25
COG 13-26
COG 13-29
In case of FREE,
input the number
of teeth manually
SET
2sec.
SET
Change
MODE
Switch between
combinations
SET
F R E E
op gear R1
Lowest gear R9 or R10
9speed cog set
COG 11-21
COG 11-23
COG 12-21
COG 12-23
COG 13-23
COG 13-26
COG 13-28
F R E E
MODE
Increases the
number of teeth
S/S
Decreases the
number of teeth
SET
Goes to next gear
S/S MODE
Back to
previous gear
- 7
UK