Electric Connection Rules; D- Using Your Deep Freezer; Start-Up - Ugur UED 150 A++ Bedienungsanleitung

C- INSTALLATION OF YOUR DEEP FREEZER

Electric Connection Rules

The product will start when you insert the plug into the outlet as shown in picture 18.
WARNING!
• It is forbidden to insert the plug into multiple socket and to use extension cord. (Picture 19)
• There is no separate on-off switch on your product.
• Do not contact the cables of your product, which are connected to the mains, to hot surfaces.
The outlet you will use must be grounded. Furthermore, the outlet to be used must have the resistance
of at least 10-16 A and be protected with a suitable fuse. Definitely take assistance from our technical
service or a competent electrician with regards to the fuse that should be present on the mains where
the outlet is connected.
Mains voltage and frequency must be same with the value written on the label inside your product. If
your mains voltage is extremely below or above the value indicated, definitely supply demanded voltage
by using a voltage regulator. You can get assistance from an expert electrician with this regard.
Do not place your product's cord onto passageways. This may cause you to get injured and damage your
cooler. (Picture 20)
EN
PICTURE 18 PICTURE 19 PICTURE 20
46

D- USING YOUR DEEP FREEZER

Start-up

WARNING!
• This operating manual applies for various device models. Hardware scopes of the models may vary. There
may be differences in the pictures.
• Clean inside and all accessories of your product before the first start up. (see page 26).
• If your product has been shaken so much during the transportation and positioning, wait for one (1) hour
without running your freezer. Thus, the compressor oil, which may enter into the system, will return back.
You may damage the compressor if you run it without considering this.
• Insert your product's plug into an outlet with alternative current of 220-240V/50 Hz only, which has been
installed according to the regulations. (Picture 21)
You will hear a slight sound from the compressor when your product is
running.
Green and red check lamps will light upon turning on your product.
Upon first operation of your product, press fast (super) freezing button
in yellow colour. Thus your freezer will make deeper freezing.
PICTURE 21
Control Panel (Optional)
Indicators and controls on the control panel of your products are shown in Picture 22 below.
Yellow Red Green
PICTURE 22
Alternative control panels
1) Thermostat setting button for setting the internal temperature of your product: When you put the thermostat setting
to "S" position or press the super button for the first time, you will run fast (super) freezing function that you can use
during the initial operation or when you want a faster freezing.
2) Fast (super) freezing lamp (yellow light) that you can use during the initial operation or when you want a faster
freezing.
3) Alarm indicator that warns you with red light when internal temperature of your product reaches to critical levels.
4) Energy lamp showing your product is powered (Green light).
Alternative
control
46 5
3
2
panels
1 7
8
0
9
MAX
I
0
4
SUPERA LARM
3
2
1
0
47
EN
5
6
7