C- Installation Of Your Deep Freezer; Selecting The Place Of Installation; Positioning; Installation - Ugur UED 150 A++ Bedienungsanleitung

C- INSTALLATION OF YOUR DEEP FREEZER

Selecting the place of installation

The operating environment of the product is very important for the smooth operation of your product. While selecting the operating
environment,
Do not place your product exposed to outdoor environment (on the street, balcony, roof, avenue, etc.).
Be careful for not obstructing lower shutter of the product with materials such as cardboard, box etc. for a proper cooling. (Picture 13)
Place the product at least one (1) meter away from heat resources (stove, radiator, electric heater etc.). (Picture 14-15)
Do not place it opposite to the air conditioner chutes, under fans and direct door and window openings. (Picture 16)
Do not expose to direct sunlight. Operation ratio will increase if sunlight comes to your cooler's glass. That means an increase in the
energy consumption.
Air intake and outlet must absolutely be fluent and free for proper operation of the compressor section of your product.
While approaching your product to the wall, be careful that there is a gap of 150 mm (15 cm) between the wall and back of your
cooler.
WARNING!
In very humid environments, ensure that floor and wall of the place where the freezer is located, is not affected by
water; against discharge water overflow danger.
In installations performed by Authorized Uğur Service, Authorized Uğur Service shall inform the consumer on the
suitable place for installation and make suggestion, but the consumer shall give the final decision on where the
installation will be made. This above mentioned process shall also be stated on the relevant installation form by
Authorized Uğur Service. In case of any loss arising from the place of installation of the product according to the
final decision given by the consumer, all responsibility related to such loss shall belong to the consumer.
EN
Your cooler gives the best cooling performance according to the climate condition under the conditions given below.
Therefore, be careful that the temperature of the environment where your cooler will operate is at these levels.
In Domestic Products:
Climate Class Acceptable Ambient Temperature
Class T +16 °C to 43 °C
Class ST +16 °C to 38 °C
Class N +16 °C to 32 °C
Class SN +10 °C to 32 °C
PICTURE 15
PICTURE 13 PICTURE 14
PICTURE 16
44
C- INSTALLATION OF YOUR DEEP FREEZER

Positioning

Possible placement positions:
1- In a way that the back side alone is opposite to the wall; be careful that there is a gap of 150 mm (15 cm)
between the wall and your cooler. (Picture 17)
2- In a way that is place to a corner; when you place it to a corner, leave a gap of 150 mm (15 cm) behind.
You can lean the side, corresponding to the corner, to the wall.
The most important point to be considered in all cases of product placement is not to obstruct ventilation
of the compressor assembly.
Without exposing your product to any slope, place and operate it in a manner that it is on its feet or
wheels.
The freer the compressor assembly ventilation is, the better the device will run.
PICTURE 17

Installation

Before positioning, remove and disassemble all packaging materials and bottom wooden pallet of the
freezer. (It may be necessary to lift the cooler for removing the bottom pallet).
Insert the replacement parts inside your product according to the installation instructions. Only use ge-
nuine Uğur spare parts.
Inauthentic spare parts may constitute danger for you and damage your product.
Place the product anywhere you desire. Consider the placement rules written in the manual while posi-
tioning the product.
Balance your product in width and in depth by means of a water gauge.
In models with wheels (optional), wheel brake (optional) must be locked or if there is no wheel brake, it
must be guaranteed that the device will not move after the positioning of the product.
45
EN