Charging The Battery - ausdom AH2 Anleitung

5. Charging the Battery

1.Connect the headphone to a power supply using the included
USB charging cable.
2.Charge the headphone for 2-3 hours until the solid red LED
goes off.It means the headphone is fully charged.
Note:
During the first charge, don't disconnect the headphone from the
power supply even if the LED Indicator on the headphone
indicates that the battery is fully charged. Leave it to charge at
least 2-3 hours in order to ensure fully charged.
The LED Indicator flashes red and sounds an alert tone (the
battery voltage is under 3.3V) that indicating the headphone is in
the low battery status. When the battery voltage is under 3.1V,
the headphone will power off. Playtime varies according to
volume level and audio content.
6. Pairing Configurations
1.Press and hold the power button on the headphone until it
powers on but don't let go just yet. Continue holding down on the
power button until you see the LED indicator flashes blue and red
alternately, which means your headphone is in"pairing
mode"waiting to be paired with your device.
2.Turn on your device, and then enable the Wireless feature.
3.Your Wireless device will list the new device that can be
connected.
4.Select "AUSDOM AH2". If your device prompts for a code or
PIN, enter "0000". After the connection is made, the LED
Indicator on your headphone turns solid blue and sounds a alert
tone indicating the Wireless wireless connection has been
completed already.
Headset
Micro USB Charging cable
EN-3
Laptop for power supply