Silvercrest SFR 37 B1 Bedienungsanleitung Seite 17

Cutting long hair
Use the long hair trimmer 15 on the back of the shaver to shorten
your beard and sideburns.
1. Take off the protective lid 14.
2. Push the long hair trimmer 15 up.
3. Switch on the shaver with the on/off 6 switch.
4. After use, switch the device off, slide the long hair trim-
mer 15 back to its original position and clean the device
(Chapter "Cleaning and maintenance of the device" on
page 16).
Designer stubble
NOTE: depending on beard growth and shaving, the appear-
ance of a designer stubble can vary greatly.
To maintain a designer stubble look, shave dry with an attached
protective lid 14 regularly. In this case, the protective lid acts as
a designer stubble attachment.
• Shave your face as described in the chapter Dry shaving (Re-
chargeable battery and mains operation).
Cleaning symbol
The device's built-in timer adds up the shaving times. After a shav-
ing period of 30 minutes, the cleaning symbol 12 starts flashing.
It is a reminder to clean the device regularly. If you switch off the
device while the cleaning symbol is flashing, the timer will start
back at the beginning when counting the shaving time.
15
GB