Weidmuller PrintJet Handbuch Seite 10

5. Printer operating panel
LED 3
LED 4-6
Button 4
Button 1: Setting the fusing unit power ratio and temperature:
This button allows you to adjust the power ratio of the fusing unit to suit different types of markers.
The device is set to 100% power when turned on; the LED for 100% lights up
Press once: The device is set to 80% power when turned on; the LED for 80% lights up
Press twice: The device is set to 60% power; the LED for 60% lights up
Press three times: the fusing unit is turned off, for example, to test the ink nozzle or adjust the print head.
Press four times: the device performs to 100%; the LED for 100% lights up.
Button 2: Replacing the ink cartridge:
Manual control over replacing the ink cartridge.
Moves the print head into position for replacing the ink cartridge when empty, and starts the ink carriage change sequence.
Button 3: Maintenance button:
To manually clean the ink cartridge
Press and release this button again within 3 seconds to draw paper into or eject paper out of the device.
Following the error message "Paper Out", press this button to continue the printing process once paper has been loaded.
To initiate the print head cleaning process, press this button continuously for 3 seconds when the error indicator LED
Press this button to move the print head to the replacement position when the ink cartridge is empty.
Button 4: Reset button:
For manually resetting the PrintJet when a fault occurs.
If it is not possible to acknowledge a fault in the PrintJet by pressing button 3 or via the status monitor, press the reset button once to reset
the printer. A paper jam is indicated by LED 1 or by the status monitor.
Button 5: On/Off button
Press to turn the printer on or off.
When the printer is on, press this button twice to delete print jobs.
LED 1: Error message (red LED):
There is a fault.
The red LED lights up when there is no MultiCard is in the printer. Place a MultiCard into the feeder and press the maintenance button
to proceed with the printing process.
It lights up when a MultiCard becomes jammed in the printer. Remove all MultiCards from the feeder, then re-insert correctly. When the LED
indicator no longer flashes, turn off the printer and carefully remove the MultiCard from the printer.
It flashes when the black ink cartridge or the Clean Unit is almost empty.
It lights up when either the black ink cartridge or Clean Unit are empty. Replace either the black ink cartridge or Clean Unit as required.
It flashes when the print head moves to the ink-cartridge replacement position. The LED flashes more quickly when the Clean Unit is empty
than when the black ink cartridge is empty.
Button 1
Button 5
LED 2
Button 3
LED 1
Button 2
is not lit up.
9