Fuel - attika Q-BE INSERT Bedienungsanleitung

English
In order to guide the hot air out
of the convection vents, install a
beveled non-combustible plate
(such as Fermacell) just above the
vents.
Air system with ø100
mm flexible piping.

Fuel

The stove has been tested in accordance with EN13240:2001, EN13240:2001/A2:2004 and NS
3058/3059 for stoking split, dried birchwood, and is approved for broad-leaved/coniferous tree
wood. The firewood must have a water content of 15-20 % and its maximum length should
be 25 cm with logs upright in the combustion chamber.
Firing wet firewood causes both soot, environmental pollution and bad fuel economy. Freshly
cut wood contains approx. 60-70% water and is thoroughly unsuitable for stoking. Count
min. 1-2 years of storage time for newly cut wood before using. Wood with a diameter of
more than 100 mm should be split. Regardless of wood size, it should always have at least one
surface area free of bark.
attika
RAIS/
Convection holes should be
C-C
located just below the beveled
plate.
- User Manual Q-BE INSERT
Distance to ceiling
can be min. 0 mm.
Distance from frame to the
floor can be 0 mm.
13