Specifications; Ec Declaration Of Conformity; Additional Safety Rules - Makita 7104L Bedienungsanleitung

ENGLISH
1-1. Wing bolt
1-2. Stopper pole
1-3. Stopper
2-1. Lock-off button
2-2. Switch trigger
3-1. Adjusting screw
3-2. Chain bar
3-3. Chain cover
3-4. Hex bolt
4-1. Arrow
4-2. Sprocket
4-3. Hex bolt
6-1. Lever (A)
6-2. Vise lever
6-3. Rear vise

SPECIFICATIONS

Capacities
Width of applicable workpiece
Chain speed (min
Dimensions (L × W × H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for cutting mortise in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the
operator from electric shock. Use only three-wire
extension cords which have three-prong grounding-type
plugs and three-pole receptacles which accept the tool's
plug.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 90 dB (A)
sound power level: 103 dB (A)
Wear ear protection.
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN61029.
Explanation of general view
7-1. Setting handle
7-2. Front vise
8-1. Indicator plate
8-2. Indication plate
8-3. Cutting line (A)
8-4. Cutting line (B)
9-1. Hook
10-1. Hex bolts
10-2. Gauge plate
10-3. Travel distance (D)
10-4. Lever (B)
11-1. Lever (C)
12-1. Adjusting hex bolt for No. 1 set
position
12-2. Lever (C)
Model
Max. hole length (Longitudinal)
Max. hole depth
-1
)
Net weight
Safety class
2
.
ENE062-1
For Model 7104L
EC-DECLARATION OF CONFORMITY
ENF001-1
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN61029, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
000087
ENG037-1
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan

ADDITIONAL SAFETY RULES

1. Use this tool only to cut holes in wood.
2. This tool is for cutting holes in flat-surfaced
wood. Never use it for cutting holes in a log.
3. Wear ear protectors.
4
12-3. Adjusting hex bolt for No. 2 set
position
13-1. Original position
13-2. No.1 set position
13-3. No.2 set position
13-4. Indication plate
13-5. Ruler
14-1. Front base
16-1. Limit mark
17-1. Brush holder cap
17-2. Screwdriver
7104L
130 mm
155 mm
80 mm - 308 mm
300 m
512 mm × 298 mm × 513 mm
17 kg
Class I
Yasuhiko Kanzaki CE2005
Director
ENH003-5
ENB093-1