Receipt Of Centrifuges To Repair; Transport, Storage And Disposal; Transport; Storage - OHAUS FC5718R Bedienungsanleitung

TM
Frontier Centrifuge FC5714/FC5718/FC5718R/FC5816/FC5816R

7. RECEIPT OF CENTRIFUGES TO REPAIR

Health risk from contaminated equipment, rotors and accessories.
In case of returning the centrifuge for repairing to the manufacturer, please notice the following:
The centrifuge must be decontaminated and cleaned before the shipment for the
protection of persons, environment and material.
Decontamination certificate at goods return delivery (See APPENDIX)
We reserve the right to not accept contaminated centrifuges.
Further on all costs occurred for the cleaning and disinfection of the units will go to
the debit of the customer's account.

8. TRANSPORT, STORAGE AND DISPOSAL

8.1 Transport

Before transporting, take out the rotor.
Only transport the unit in the original packaging.
Install the transport protection material to secure the motor shaft, when
transporting over longer distances.
General transportation

8.2 Storage

During storage of the centrifuge the following environmental conditions must
be observed:
in transport packaging
8.3 Transporting, Installing, Transferring and Disposing of the Centrifuge FC5714/FC5718/
FC5718R/FC5816/FC5816R
These instructions complement the previous general instructions in
chapter 8 and do not replace them.
8.3.1 Transport
•
Please transport the device in the original packaging.
•
The centrifuge should always be transported using a mechanical
transport device.

8.3.2 Installation

 Opening the carton and lifting out the device.
1. Cut the adhesive tape.
2. Open all 4 flaps of the carton.
3. Remove the accessories.
4. Carefully lift the centrifuge from the carton.
WARNING: Lifting Hazard. Single person lift could cause injury. Use a mechanical lifting
device or team lifting procedures when lifting or moving the equipment.
Air temperature rel. humidity
-25 to 60 ° C 10 to 75 %
Air temperature rel. Humidity
-25 to 55 °C 10 to 75 %
Air pressure
30 to 106 kPa
Air pressure
70 to 106 kPa
EN-21