Replacement Or Installation Of Rotor - OHAUS Frontier 5000-Serie Bedienungsanleitung

EN-4
2.2

Replacement or Installation of Rotor

1. When the machine is delivered from the factory, the seizing shaft
sleeve and angle rotor are firmly fixed on the shaft of the drive motor.
2. If it is necessary to dismantle an installed rotor, the user should hold
the outside edge of the rotor, and push the protruding clamp towards
its center with two thumbs, then lift the rotor upwards.
3. To reinstall rotor, align the oval hole of rotor over the clamp, then
gently press down the rotor until the clamp clicks into place.
Frontier
角转头
Angle Rotor
Clamp
Motor Shaft Sleeve
电机轴套
TM
FC5306