Description Of The Error Message System - OHAUS FC5718R Bedienungsanleitung

EN-20
ATTENTION:
a) Just turn to the limit, don´ t tighten the nut.
b) Now open the lid of the centrifuge.
c) Switch the centrifuge on again, to resume work.
For 5714
Please proceed as follows (see Figure xx):
ATTENTION:
•
Switch the centrifuge off and unplug the power cord, wait until the rotor stands still (this may
take several minutes). At the right side of the centrifuge there is a plastic stopper (Figure 38).
Remove this stopper, which is connected to the lid lock, horizontally from the housing until the
centrifuge lid opens.
•
Now open the lid of the centrifuge

6.2.2 Description of the error message system

The error message "error" (M11) is shown in the "Time/Prog" (A-3) display (See figure 39). Detailed information
about possible error messages are in "table 6: error messages" (See Appendix).
TM
Frontier Centrifuge FC5714/FC5718/FC5718R/FC5816/FC5816R
M11
Figure. 37
Figure. 38
A-3
Figure. 39