Chauvin Arnoux MN93 Bedienungsanleitung Seite 21

I
„ At the end of the measurement, remember to switch off the PAC93.
For the AmpFLEX
„ Press simultaneously on both sides of the opening device.
„ Then clamp the cable that is to be measured. Where possible, the cable should
be centred in the sensor.
„ Close the sensor by forcing the moving part into the connector until you hear
a click.
For details of the measurement configuration and technical characteristics, re-
fer to the user manual of the C.A 8320, C.A 8330, C.A 8332, C.A 8334 or C.A 8335.
models:
TM
21