Temperature Display; Switching The Weighing Function Off; Troubleshooting; Changing The Batteries - Silvercrest KH 1157 Bedienungsanleitung

You can reset the timer.
➩ Press the sensor area T-SET
As soon as the programmed time has expired, an
acoustic signal sounds. This signal can be switched
off by pressing on any sensor area.

Temperature Display

When the scale is switched on, the display
shows the temperature in °C at the top right.

Switching the weighing function off

If you do not weigh anything for ca. 2 minutes the
scale automatically switches into the clock mode.
➩ To switch over to the clock mode manually, press
the sensor area ON/OFF

Troubleshooting

➩ If the display
e
shows "Err", the scale is overbur-
dened. Remove material from the scale. Never
place more than 5 kg on the scale.
➩ If the display
e
shows "Err" for a short time and
the weighing mode cannot be switched on, the
scale is overburdened. Remove the items to be
weighed from the scale and then switch the sca-
le on again. Place less than 5 kg on the scale.
➩ If the display
e
shows "Lo", the batteries are di-
scharged. Replace the batteries.
The notification "Lo" appears only in weighing
mode.
➩ Should „- - - -" appear in the display
few seconds.
➩ If your scale does not function as expected, re-
place the batteries. Should the malfunction not be
eliminated with these steps please make contact
with our Service Centre (see "Warranty and
Service").
i
to re-set the timer.
e
t
.
e
, wait a

Changing the batteries

Warning!
Pay attention to the correct polarity when exchan-
ging batteries. Incorrect battery exchange could
lead to the danger of an explosion.
Only exchange batteries for identical or equivalent
types. Should the batteries leak, wear protective
gloves and clean the battery compartment with a
dry cloth.
Poison Hazard!
Batteries can be swallowed by children and cause
impairment of health. Keep batteries out of the reach
of children.
➩ To change the batteries, open the battery com-
partment cover on the underside of the scales.
➩ Press the metal loop on the battery retainer out-
wards so that the batteries are released.
➩ Remove the old batteries and replace them with
new ones. Take note of the correct polarity: The
side of the battery marked with a "+" must show
to the top.

Storage

When the kitchen scale is not in use it can be hung
up by means of the integrated suspension
example on a kitchen ledge.

Cleaning

Attention!
Ensure that no fluids can enter the scale. Permeating
liquids can damage the scale.
- 5 -
q
, for