Setting The Timer; Temperature Display; Switching The Weighing Function Off; Troubleshooting - Silvercrest KH 1159 Bedienungsanleitung

Setting the Timer

The timer can be used in both a clock and a weighing
mode.
Der Timer enables you to set the clock for a specific
period of time, at the end of which a signal tone sounds.
The preset time runs as in a countdown.
➩ Press the T-SET button
the bell symbol
You can adjust the time accurately to the second.
If you hold down the ▲ Z/T
buttons, the time-indicators run through faster.
➩ Using the ▲ Z/T
y
programme in the desired ten-minute setting.
➩ Press the T-SET button
or the ▼ UNIT
t
button, programme in the des-
ired one-minute setting.
➩ Press the T-SET button
or the ▼ UNIT
t button, programme in the des-
ired ten-second setting.
➩ Press the T-SET button
or the ▼ UNIT
t
button, programme in the desired
one-second setting.
➩ Press the T-SET button
You can reset the timer.
➩ Press the T-SET button
As soon as the programmed time has expired, an
acoustic signal sounds. This signal can be switched
off by pressing on any button.

Temperature Display

When the scale is switched on, the display
shows the temperature in °C at the top right.
r
once. In the display
appears in the above-left.
or the ▼ UNIT
y
or the ▼ UNIT
t button,
once. Using the ▲ Z/T
r
once. Using the ▲ Z/T
r
once. Using the ▲ Z/T
r
r
to start the countdown.
r
to re-set the timer.
w

Switching the weighing function off

If you do not weigh anything for ca. 2 minutes the
scale automatically switches into the clock mode.
➩ To manually switch over to the clock mode, press
the button ON/OFF
➩ When you no longer require the scales, fold the
w i
glass plate

Troubleshooting

t
➩ If the display
burdened. Remove material from the scale.
Never place more than 4 kg on the scale.
➩ If the display
y
weighing mode cannot be switched on, the scale
is overburdened. Remove material from the scale
and then switch the scale back on again.
y
Place less than 4 kg on the scale.
➩ If the display
depleted. Replace the batteries.
y
The indicator "Lo" only appears in the weighing
mode.
➩ If „- - - -" appears in the display
seconds.
➩ If your scale does not function as expected, replace
the batteries. Should the malfunction not be
eliminated with these steps please make contact
with our Service Centre (see "Warranty and
Service").
- 5 -
u
.
back upwards.
w
indicates "Err", the scale is over-
w briefly indicates "Err" and the
w indicates "Lo", the batteries are
w , wait a few