Maintenance; Daily Maintenance; Weekly Maintenance; Monthly Maintenance - Viper FANG 32T-EU Bedienungsanleitung

bottom of the sight tubes. Replace the caps and wipe the batteries down with a towel.

MAINTENANCE

To keep the machine performing well for many years, please follow the following maintenance procedures.
CAUTION!
Always confirm that the machine is switched off and the battery cable is disconnected prior to performing any
mainte-nance or repairs

DAILY MAINTENANCE


Remove pad driver / brush and clean with approved cleaner.

Drain recovery and solution tanks completely and rinse out with clean water. Visually check the recovery tank for debris
and clean out as necessary.

Raise squeegee assembly off floor and wipe it down with a damp towel. Be sure to store the squeegee in the up position.

Remove the float shut-off assembly and rinse it out with clean water.

Clean machine with an approved cleaner and a damp towel. Don't spray water to clean the outside of machine to avoid
damage to motor and wiring.

Recharge batteries.

WEEKLY MAINTENANCE


Check fluid level in batteries.

Check batteries for loose or corroded cables.

Keep battery tops clean from corrosion.

MONTHLY MAINTENANCE


Check machine for leaks and loose fasteners.

Lubricate all grease points and pivot points with silicon spray and approved grease.

Place machine over a floor drain. Flush solution system by pouring 10 liters of hot water and approved alkaline detergent
into the solution tank and running machine (with solution control on) for 45 seconds. Turn machine off and let it sit
overnight. Then next day, drain the remaining solution and rinse the solution tank out with clean water.

VACUUM SYSTEM MOTOR FILTER CLEANING


Drive the machine on a level floor.

Turn the ignition key (19) to "OFF".

Open the recovery water tank.

If necessary, drain the water from the tank in order to make the filter visible.

Check that the pre-filter is clean. If necessary clean it with water and compressed air, then install it.

Perform steps 1, 2 and 3 in the reverse order.

SOLUTION/CLEAN WATER FILTER CLEANING


Drive the machine on a level floor.

Turn the ignition key (19) to "OFF".

Remove the transparent cover (D) (the water filter position is under the machine), then remove the filter strainer (B).
Clean and install them on the support (A).
USER MANUAL
ENGLISH
23