Cable Retainer; Connecting The Power Supply - Silvercrest SWKL 2200 A1 Bedienungsanleitung

Cable retainer

A cable retainer
allows you to adjust the length of the cable to your local requirements.
CAUTION – PROPERTY DAMAGE!
► Ensure that you always guide the cable through the corresponding gap in
the rear of the base
NOTE
► Always wrap the power cable around the cable retainer
direction. This reduces the length of the cable to a minimum, allowing you
to guide the cable through the gap in the base

Connecting the power supply

CAUTION – PROPERTY DAMAGE!
► Before connecting the appliance, compare the connection data of the
appliance (voltage and frequency) on the rating plate with that of your
electrical supply. This data must correspond in order to prevent damage to
the appliance.
♦ Unwind the power cable from the cable retainer
♦ Guide the power cable through the gap in the back of the base
♦ Insert the plug into a mains power socket. You will hear a beep and all but-
tons will light up blue briefly. When the jug
control lamp
appliance is now in standby mode for about 3 minutes. When the jug
not on the base
SWKL 2200 A1
is located on the base
for the sake of stability.
Fig. 1
and temperature button 100°C
, the control lamp
of the appliance. This winder
in a clockwise
(see fig. 1).
.
is placed on the base
will light up blue. The
will flash blue.
GB│IE│NI│CY
.
, the
is
7 ■
│