Recharging The Powerpette Plus; Fitting The Powerpette Plus Into The Bench Stand - VWR Powerpette Plus Bedienungsanleitung

Recharging the Powerpette Plus
Before starting to operate, carefully check mains voltage and recharge batteries.
To charge the Powerpette Plus:
Plug the charger jack (6) into the base of the Powerpette Plus.
Plug the charger (5) into a suitable wall socket. The red indicator on the charger will light up.
•
Place the Powerpette Plus onto bench stand.
Allow the unit to charge for 16 hours from empty to fully charged.
•
Once the Powerpette Plus is fully charged, the charger automatically switches to a trickle charge
operation and the indicator light turns green. If the charge to the Powerpette Plus is interrupted and
then re-started the charger will begin its 16 hour cycle and will switch to a trickle charge operation as
above. This will not damage the battery.
Only use the charger indoors and protect against moisture.
•
Recharging temperature +10 °C to +35 °C.
•
Fitting the Powerpette Plus into the bench stand
The Powerpette Plus can be fitted into the bench stand in one of the two positions
shown. It can be charged in either position.
Bench stand
|
EN INSTRUCTION MANUAL
5
|
VWR