Cup Level Adjustment; Pre-Grinding Adjustment (Only For Profimat De Luxe) - Saeco PROFIMAT Bedienungsanleitung

8 - CUP LEVEL ADJUSTMENT

CLOSE
9 - PRE-GRINDING ADJUSTMENT (only Profimat DE LUXE)
• When the pre-grinding program is activated, the machine grinds the dose for the next serving while
dispensing the coffee.
This allows the next coffee to be dispensed in a shorter time as the coffee dose is ready.
• To activate the pre-grinding program, press the
pressing the pad within 5 seconds.
• The slow blinking of the 5 leds of the coffee pads indicates that the pre-grinding program has been
activated.
• To exit this special program mode repeat the a.m. procedure.
• Attention: By activating the pre-grinding program, the coffee dose remains in the machine until the
next coffee is dispensed.
In case the machine does not work for a certain period (for example at night or on the week end) the
pre-ground coffee dose may loose its flavour and occasionally the doser may not function properly.
We therefore recommend that the pre-grinding program be activated only when actually required (for
example rush hours) and to exit the program every evening taking care to dispense at least 1 cup of
coffee after having deactivated it for the purpose of discharging the doser.
14
for the coffee to flow. To stop the flow, press any of the
pads. If the coffee flows too slowly, the grinding level has
to be increased. If the coffee flows too quickly, the
grinding level has to be reduced. Important: Prepare 2
coffees at least, after this operation, in order to enjoy the
grinding variation.
Fig. 8
• Turn the main switch to "0".
• Turn the main switch to"1"while pressing the
OPEN
pad simultaneously. When the
programming procedure is activated.
• Press the pad that has to be programmed. Press it again
when the desired cup level has been reached. Follow the
same procedure for setting all selection buttons.
• Important: The quantity for 2 cups(
coffee will be automatically adjusted by setting the
selection button. for 1 cup.
Fig. 9
• Turn off the machine by means of the main switch to exit
the program mode.
• Attention: By entering the program mode, it's possible to
change the level of only one of the pads without having to
change them all.
and the pad simultaneously. Confirm by
English
and the
led is blinking the
, )of