English; Fr156N Trimmer - Virutex FR156N Gebrauchsanweisung

E N G L I S H

FR156N TRIMMER

Important
Read these OPERATING INSTRUCTIONS
and the attached GENERAL SAFETY
INSTRUCTIONS LEAFLET carefully before
using the machine. Make sure you have
understood them before operating the
machine for the first time.
Keep both sets of instructions for any
future queries.
1. SAFETY INSTRUCTIONS
FOR THE TRIMMER USE
Carefully read the GENERAL SAFETY
INSTRUCTION LEAFLET enclosed with the
machine documents.
1. Supply voltage must be the same as that indicated
on the specifications plate.
2. Keep hands away from the cutting area. Hold firmly
the machine when working.
3. Use always Virutex original bits. Never use malformed
or broken bits.
4. Always use bits with the correct size of shank for the
chuck being used and adjust the velocity of the tool.
Unplug the machine from the electrical
outlet before carrying out any handling
operations.
5. The brake pivot R (Fig. 8) must be placed on the front
(not the edge) of the bit bearing.
2. SPECIFICATIONS
Input power......................................................750 W
Equivalent measured continuous
acoustic pressure level.........................88 dB(A)
Acoustic power level.............................101 dB(A)
Usual level of vibrations (hand-arm).......<2,5 m/s
No-load speed...........................14000-30000/min
Chuck collet................................................8 mm
Weight........................................................1,6 Kg
3. STANDARD EQUIPMENT
Inside the box you will find the following items:
• FR156N trimmer fitted with dust collector connection
6
bit for 3 mm radius and 8 mm shank diameter. (ATTEN-
TION: In the FR256N edge trimming set the bit included
as standard equipment has a radius of 2 mm).
• A/f key: 11 mm for the motor shaft.
• A/f key: 19 mm for the chuck collet.
• Head bases with a pitch diameter of 26 and 30.
4. GENERAL DESCRIPTION
OF THE FR156N TRIMMER
The main function of the machine is the finishing of PVC,
melamine and wooden edges. These may be straight and
angled or curved, depending on the bit used. Shaped
finishes can also be obtained using different VIRUTEX
bits with bearings. The machine is fitted with a dust
collector connection for attaching our AS182K and
AS282K dust collectors or any other industrial dust
collector, using the standard dust collector attachment
(Ref. 6446073).
The dust collector connection incorporates a sprung
brake pivot R (Fig. 8), whose purpose is to slow down
the outer bearing ring, preventing it turning with the
bit and possibly damaging the surface of the panel when
placing the trimmer in the working position.
5. ADJUSTMENTS
Unplug the machine from the electrical
outlet before making any adjustments.
To adjust the bit outlet, loosen knob B on the head,
regulate screw A to move the bit and then fasten it in
place again (Fig. 3).
6. STARTING UP THE MACHINE
To start the machine, press button E forward (Fig. 1) to
the on position. To stop the machine, simply press the
back of the switch and it will return to the off position.
The electronic control enables you to work at the ideal
speed for each type of job and bit. Adjust the speed
using button K (Fig. 2).
7. CHANGING THE BIT
Disconnect the machine from the power
supply before this operation.
2
-1
Loosen knob B (Fig. 3) and remove the head. To change
the bit (Fig. 4), block the motor shaft using key C, unscrew
the chuck with key D and remove the bit.
Insert the new bit into the housing and hold it in
place using the service keys, then fit the head back
in position.