Operation And Parameter Settings - Sick Pac50 Bedienungsanleitung

Operating Instructions

7 Operation and parameter settings

7.1 Initialization
Once the power supply has been connected, all segments on the display light up for 2 seconds in the primary
color, then 2 seconds in the warning color to check all segments are functioning correctly. The following
indications are then displayed for 2 seconds:
Display area A: "SICK"
•
Display area B: "PAC50"
•
Display areas C2 and E2: "Firmware revision"
•
The device then enters display mode.
7.2 In operation: Display mode
The measuring and switching functions are in operation.
The device has an energy-saving mode which switches off the display ("DISC" function). In energy-saving
•
mode (DISC: OFF), the display is briefly reactivated (10 seconds) when one of the pushbuttons is pressed.
7.3 Info mode
Pressing the pushbutton for a longer period (> 3 s)
seconds each (see "Parameter info" in Section 2). The device returns to display mode subsequently:
SP1/FH1 (Settings for switching point 1/upper window limit 1)
•
RP1/FL1 (Settings for reset point 1/lower window limit 1)
•
SP2/FH2 (Settings for switching point 2/upper window limit 2)
•
RP2/FL2 (Settings for reset point 2/lower window limit 2)
•
Analog output (electrical output signal in mA or V)
•
LOW (minimum applied pressure value that has been stored since the last reset)
•
HIGH (maximum applied pressure value that has been stored since the last reset)
•
Return to display mode by pressing the buttons
.
8017612/YJ70/2015-02-24 | PAC50
Subject to change without notice
7 Operation and parameter settings
displays the following parameters consecutively for 3
and simultaneously or by pressing the middle button
O p e r a t i n g I n s t r u c t i o n s | S I C K
PAC50
5 9