First Time Installation - Finlux 37FLHD760 Bedienungsanleitung

By pressing  or 

item. Press or

item and then use 

pressing or

Language and use
finished, press OK button to continue:
APS is running...
After APS is finalized, the programme table
will appear on the screen. In the programme
table you will see the programme numbers
and names assigned to the programmes.
If you do not accept the locations and/or the
programme names, you can change them via
Program Table. See "Install Menu" section.
All channels found are stored in a sorted form
with respect to their channel numbers. Some
services may not appear with the correct
channel number. This is because some
broadcasters have no channel number
information.
Manual Search
In Manual Search, the number of the multiplex
is entered manually and only that multiplex is
searched for the channels. For every valid
channel number, signal level, signal quality
and network name are shown at the bottom
of the screen.
In both manual and auto search any existing
channel in the database is not re-stored to
avoid redundant duplicates of that channel.

First Time Installation

The user can use this item to load default
settings, which were loaded to the receiver at
the factory.
button, set the Language
button to highlight Country
or  to set. Afterwards, by
button, highlight Text
 or  to set. W hen
Cancel
To install factory settings, highlight "First Time
Installation" menu item and press OK button,
then you will be asked whether or not to delete
the settings. Selecting "Yes" by pressing OK
button while the "Yes" is highlighted will delete
the existing channel table.
Are you sure you want to delete all channels and
settings for first time installation?
After factory settings are loaded, "First Time
Installation" menu will be displayed.
The menu which is displayed for language
selection appears on the screen at first. By
using or

language option, and press OK button to
activate.
After the language is selected, a message asking
for automatic search appears on the screen:
Do you want to start automatic search?
Highlight "Yes" item by pressing
and press OK button to start installation. After
search is completed for digital channels, a
message asking whether to search for
analogue channels appears on the screen:
Highlight "Yes" item by pressing
and press OK button to search for analogue
channels. The following menu appears on
the screen for analogue channel search:
English - 24 -
Yes No

buttons, select the desired
Yes No
Do you want to search for
analogue channels?
Yes No
 or  buttons
 or  buttons